Valves

3V: 3 Way
4V: 5 Way
Pneumatic Control Valve
Air Valves

Actuator: Stainless steel
Working Pressure: 0.05-0.95 Mpa
Long lifespan

we specially invest and put more effort to develop air solenoid valve products and equipments to meet quality of ISO9001 procedures

Voltage: DC12V,DC24V,AC36V,AC110V,AC220V,AC380V
Pressure Range: 30(5)-860(125) kPA(Psi)

These closed center valves have a 90° lever movement. In neutral position, the inlet is closed to pressure and outlets are closed to exhaust.

Body: Aluminum
Flow coefficient KV: 77 m3/h 1290 L/min
Working pressure: 0.35-0.85Mpa

The mainly products are Hand-control Valve,Pneumatic Control Valve,pneumatic
accessories,one-way throttles,direction valves,and so on

Diaphragm kits: K7600,K7601
Intergral Pilot and Remote Pilot type
Pressure Range: 30(5)-860(125) kPA(Psi)

usually an actuator, allowing a relatively small signal to control a large device.

Body SS316
Coil Special Copper Wire (H)
Standard voltage : 24VDC,110VAC, 220VAC
DIN43650A connector Coil is interchangeable

solenoid valve is the interface between electronic controllers and pneumatic systems.

Thread: BSPT, NPT , BSP.
The standard product fluid temperature is 80°C(NBR).
Temperature:Viton(130°C), Silicon(130°C), PTFE(185°C).

A pneumatic solenoid valve is a switch for routing air to any pneumatic device, usually an actuator,

Port Size: 1/4"
Materials: Housing: Aluminum anodized Pilot flange: plastic (POM) Seals: NBR
Wroking Pressure :1-10bar

we are the professional pneumatic solenoid valve manufacturers.

Port Size: 1/4"
Materials: Housing: Aluminum anodized Pilot flange: plastic (POM) Seals: NBR
Wroking Pressure :1-10bar

we are the professional pneumatic solenoid valve manufacturers.

Port Size: 1/2"
Materials: Housing: Aluminum anodized Pilot flange: plastic (POM) Seals: NBR
Wroking Pressure :1-10bar

equipments to meet quality of ISO9001 procedures to meet world standard and internationalized specification.

Port Size: 1/2"
3/2 way,single solenoid valve
Housing: Aluminum anodized Pilot flange: plastic (POM)
Wroking Pressure :1-10bar