lubricating oil tester

DST Insulating dielectric oil breakdown voltage tester is actually controlled through single-chip microcomputer.

IIJ-II series fully automatic oil tester is apply to test the insulating oil's dielectric strength.

Series IIJ-II oil tester is special for testing transformer oil's dielectric strength. IIJ-II Automatic oil tester is designed according to IEC156.

APYJ-501 is developed according to the national standard GB-86 Insulating Oil Dielectric Strength Testing Method .

Engine Oil Pressure Tester

Fully automatic Insulating oil tester determine transformer oil properties and identify issues, fast,IEC156

1)power:AC220V±10% 50Hz
2)capacity range:100W-1000W
3)buret accuracy:calibration 0.02ml
4)size:200L×200W×500H
5)weight: 10 kg

The instrument is designed and made as per GB/T261 "Test Methods for Flash Point of Petroleum Products (Closed Cup Methods)".

teste insulating oil dielectric strength

Engine Oil Pressure Tester set

This instrument is designed and made as per standards GB/T 11143 and ASTM D665. It is suitable to determine the ability of inhibited mineral oils,part

1.3" Diameter Oil Pressure Gauge calibrated in PSI or Bar with protective rubber boot.
2.100 PSI Rated 24" long rubber hoses with brass fittings.

This instrument is designed and made as per standards GB/T 11143 Standard test method for rust-preventing characteristics of inhibited mineral oil .

1.SH/T0308-92
2.It is used to determine air release value of fire resistant oil, hydraulic oil, turbine oil and other petroleum products.

Lubricating Oil Rust Characteristics Tester is suitable to determine rust-preventing characteristics of inhibited mineral oil.

SYD-11143 Lubricating Oil Rust Characteristics Tester is made as per the National Standard GB/T11143,ASTM D665, and IP135.

The oxidation tester is to test the oxidation stability of new or in service turbine oil, which has the same component

1.GB/T11143 "Test Methods for Rust-Preventing Characteristics of Inhibited Mineral Oil in the Presence of Water"
2.ASTM D665-12 Standard Test Metho

Lubricating Oil Sulphur Content Tester
Sulphur Content Tester
dark oil sulphur analyzer
sulfur content of dark petroleum

Lubricating Oil Air Release Value Tester determine air release value of fire resistant oil, hydraulic oil, turbine oil etc.

Lubricating Oil Sulphur Content Tester
Sulphur Content Tester
dark oil sulphur analyzer
sulfur content of dark petroleum

GB/T 11143 Standard test method for rust-preventing characteristics of inhibited mineral oil in the presence of water and ASTM D665 Standard Test Meth

ZGF DC high voltage generator is DC high voltage power supply equipment. it have functions of switch on protection under 0 voltage,over voltage and ov

No need of gas source; electronic ignition; imported sensor; automatic correction of the air pressure; alerting if over value
The automatic flash p

The instrument is designed and made as per the National Standard GB/T387 "Test Methods for Sulfur Content of Dark Petroleum Products (Tubular Oven Me

Oil Automated Filter Tester Compliance
USA commercial respirator regulation (NIOSH 42 CFR part 84)
Large LCD display
Computer controller and easy

GD-4929 Oil Bath dropping point tester of lubricating grease
It is suitable to determine dropping point of lubricating grease

Model: SYP2001-3C

Car used engine oil distillation plant to get base cleaned oil, newly advanced technology without clay and acid, low power cost

1.Standard :SH/T 0168,GB/T6540,GD-0168
2.test color of oils
3.Favorable Price