UB2000 Brass Ultrasonic Proximity Sensor For Distance Measurement 200G IP67
Description
Ultrasonic sensors present the ideal solution for non-contact position and distance measurement in all industrial areas where environmental conditions such as dust, smoke or steam may affect the sensors. Objects consisting of a variety of materials can be detected to within millimeters regardless of color or shape.
Technical data
| General Specifications | |
| Sensing distance | 100…2000mm |
| Adjustment range | 100…2000mm |
| Unusable area | 0…100mm |
| Standard target plate | 100mm×100mm |
| Transducer frequency | About 112kHz |
| Response delay | About 195ms |
| Indicators/Operating means | |
| LED blue | Power on |
| LED yellow | indication of the switching state Flashing:program function object detected |
| LED red | permanently red: Error Red,flashing:program function,object not detected |
| Electrical specifications | |
| Operating voltage UB | 10…30VDC,ripple10%ss |
| Power consumption P0 | ≤900 mW |
| Output | |
| Output type | 1 analogue output 0…10V |
| Resolution | evaluation range [mm]/4000, but ≥ 0.35 mm |
| Deviation of the characteristic curve |
≤0.2% of full-scale value |
| Repeat accuracy | ≤0.1% of full-scale value |
| Load impedance | 0…500 Ohm |
| Temperature influence | ≤2% from full-scale value |
| Ambient conditions | |
| Ambient temperature | -25…70 |
| Storage temperature | -40…85 |
| Mechanical specifications | |
| Connection | Connector M12x1,4-PIN |
| Material Housing |
brass,nickel-plated |
| Transducer | epoxy resin/hollow glass sphere mixture; Polyurethane foam |
External synchronization
The sensor can be synchronised by the external application of a square wave voltage. A synchronisation pulse at the
synchronisation
input starts a measuring cycle. The pulse must have a duration greater than 100 μs. The measuring cycle starts with
the falling edge of a synchronisation pulse. A low level > 1 s or an open synchronisation input will result in the normal
operation
of the sensor. A high level at the synchronisation input disables the sensor. Two operating modes are available:
1. Multiple sensors can be controlled by the same synchronisation signal. The sensors are synchronised.
2. The synchronisation pulses are sent cyclically to individual sensors. The sensors operate in multiplex
